Infinix, Tecno и itel — бренды холдинга Transsion, почти все на чипсетах MediaTek или Unisoc. Это хорошая новость для сервиса: FRP, пароль экрана и прошивка снимаются через режим BROM без разборки телефона за 10–20 минут. Разбираем порядок и программы.
Important. Removing locks is legal only on your own device or with the owner's consent. Services do this after checking the documents for the phone. We sell tools for technicians and do not help bypass the protection of other people's devices.
Что можно сделать
- Снять FRP (Google-аккаунт) после сброса.
- Сбросить пароль или графический ключ — чаще со сбросом данных, на части моделей без потери.
- Flash or recover a phone after a failed update, repair the IMEI partition after a board repair.
- Unlock the bootloader.
BROM mode: how to connect
- Install the MTK USB VCOM driver (for Unisoc, the SPD driver). On Windows 10/11, disable driver signature verification if the installation fails.
- Turn the phone off completely.
- In the program, click the operation you need and, holding both volume buttons (on some models only “volume −”), connect the cable.
- The phone will be detected as MediaTek USB Port for a few seconds, and the program will pick it up automatically.
If the port doesn't appear: change the cable, use USB 2.0, try without pressing any buttons or with the battery removed on older models. On newer MediaTek chipsets (Helio G99 and later), BROM is protected, so you need the latest version of the program with a protection bypass.
Which programs work
- Universal tools with good Transsion support: UnlockTool, TFM Tool Pro, Cheetah Pro, Android Multi Tool, Turbo Service Mobile, UAT Pro, EFT Pro, CF-Tools.
- MediaTek specialists: Hydra Tool, Pandora, NCK.
- Authorization for new models if BROM is locked: Falcon Multi Auth.
Selection — “Programs for Infinix, Tecno and itel”. For such phones, the following is especially cost-effective: hourly rental: the operation takes minutes.
Снятие FRP: по шагам
- In the program, select the brand and model or Auto mode.
- Click Remove FRP and connect the phone in BROM mode, as described above.
- Wait for the success message and the reboot. On first startup, skip signing in to the old account.
Flashing
Firmware for Transsion devices is distributed in a format for SP Flash Tool or the program's built-in loader. Use the firmware for your model and region (the model code is on the sticker under the battery or in Settings → About phone). Before flashing, back up the NVRAM / NVDATA partitions, which contain the IMEI and calibration data.